vector.com|Contact
Search tips

apple banana
Find rows that contain at least one of the two words.

+apple +juice
Find rows that contain both words.

+apple macintosh
Find rows that contain the word 'apple', but rank rows higher if they also contain 'macintosh'.

+apple -macintosh
Find rows that contain the word 'apple' but not 'macintosh'.

+apple ~macintosh
Find rows that contain the word 'apple', but if the row also contains the word 'macintosh', rate it lower than if row does not. This is "softer" than a search for '+apple -macintosh', for which the presence of 'macintosh' causes the row not to be returned at all.

+apple +(>turnover >strudel)
Find rows that contain the words 'apple' and 'turnover', or 'apple' and 'strudel' (in any order), but rank 'apple turnover' higher than 'apple strudel'.

apple*
Find rows that contain words such as 'apple', 'apples', 'applesauce', or 'applet'.

"some words"
Find rows that contain the exact phrase 'some words' (for example, rows that contain 'some words of wisdom' but not "some noise words").

By continuing to use this site you agree to the use of cookies. For more information and to find out how to change this click here. Accept Cookies
Please enable cookies in your browser for this website.
Search:
Advanced search
Options
document
2018-03-21 Activating of the LIN Error Signal
Question: How to activate the LIN error signal permanently? Answer: See LIN Specification: Each slave shall send one status bit signal, Response_Error, to the master node in one of its transmitted frames. Response_Error shall be set whenever a frame received by the node or a frame transmitted...
2018-03-21 rating Views: 2884
document
2019-03-04 Simulation of J1939 nodes
Support Note: This Support Note describes how to simulate J1939 nodes using the different libraries (dll) that are delivered with CANoe. It first explains the difference between those libraries and then how to find the corresponding CAPL functions. Further it describes how to change the...
2019-03-04 rating Views: 2683
document
2018-10-25 VN26x0: Detection of Light Impulses on Rx
Question: When does VN26x0 start to detect light impulses on Rx? Answer: According to the specification, the Receiver FOR has latency between 2.5 and 12 ms, until it transfers from low power state to measurement activity. So at least this time interval must pass, until any events will be...
2018-10-25 rating Views: 983