Search tips

apple banana
Find rows that contain at least one of the two words.

+apple +juice
Find rows that contain both words.

+apple macintosh
Find rows that contain the word 'apple', but rank rows higher if they also contain 'macintosh'.

+apple -macintosh
Find rows that contain the word 'apple' but not 'macintosh'.

+apple ~macintosh
Find rows that contain the word 'apple', but if the row also contains the word 'macintosh', rate it lower than if row does not. This is "softer" than a search for '+apple -macintosh', for which the presence of 'macintosh' causes the row not to be returned at all.

+apple +(>turnover >strudel)
Find rows that contain the words 'apple' and 'turnover', or 'apple' and 'strudel' (in any order), but rank 'apple turnover' higher than 'apple strudel'.

Find rows that contain words such as 'apple', 'apples', 'applesauce', or 'applet'.

"some words"
Find rows that contain the exact phrase 'some words' (for example, rows that contain 'some words of wisdom' but not "some noise words").

By continuing to use this site you agree to the use of cookies. For more information and to find out how to change this click here. Accept Cookies
Please enable cookies in your browser for this website.
Advanced search

How to Set/Read the MAC Id of a CANoe Simulation

Last updated: 2018-05-17
How can I set/read the MAC Id of my CANoe Simulation?
EthGetMacId gives the real MAC Id of the Interface/Adapter that is used. Each VN56xx has got its own set of MAC Id, one for each Adapter. EthGetMacId is only available if ETHERNET_IL.dll is configured as component in the node. In case of simulated bus there is no real MAC Id available, therefor CANoe uses a simulated MAC:
  • ID 02:00:00:00:00:01 (first simulated Adapter – i.e. Eth1)
  • ID 02:00:00:00:00:02 (second simulated Adapter – i.e. Eth2)

IpGetAdapterMacId gives the MAC Id set for the simulation node. It makes for this MAC Id no difference if real bus or simulated bus is used at Measurement Start. However, it is important to differentiate which TCP/IP stack shall be used for the simulation in the TCP/IP configuration dialog. CANoe Stack is always used for Diagnostic and XCP. It can also be used by the simulated node if configured, like indicated below.

  • If use shared CANoe TCP/IP stack has been selected for the simulated node, the Ethernet setting for CANoe are used.
  • If individual TCP/IP stack has been selected for the node, the individual Ethernet setting is used for each node.

These pictures illustrate all possible use cases.

Article Options
Views: 974