vector.com|Contact
Search tips

apple banana
Find rows that contain at least one of the two words.

+apple +juice
Find rows that contain both words.

+apple macintosh
Find rows that contain the word 'apple', but rank rows higher if they also contain 'macintosh'.

+apple -macintosh
Find rows that contain the word 'apple' but not 'macintosh'.

+apple ~macintosh
Find rows that contain the word 'apple', but if the row also contains the word 'macintosh', rate it lower than if row does not. This is "softer" than a search for '+apple -macintosh', for which the presence of 'macintosh' causes the row not to be returned at all.

+apple +(>turnover >strudel)
Find rows that contain the words 'apple' and 'turnover', or 'apple' and 'strudel' (in any order), but rank 'apple turnover' higher than 'apple strudel'.

apple*
Find rows that contain words such as 'apple', 'apples', 'applesauce', or 'applet'.

"some words"
Find rows that contain the exact phrase 'some words' (for example, rows that contain 'some words of wisdom' but not "some noise words").

By continuing to use this site you agree to the use of cookies. For more information and to find out how to change this click here. Accept Cookies
Please enable cookies in your browser for this website.
Search:
Advanced search

How to Change the Default Event Channel of an XCP Device in CANape

Last updated: 2019-11-11
Question:

How can I define a default XCP event channel which is used for measuring signals of a XCP device?

Answer:

Per default CANape auto detects the event channel which can be defined for each signal in the A2L file. If a fixed or variable DAQ event is defined for a signal, it can be found in the properties of an XCP signal:

For all signals wich have no DAQ events defined, a default event channel can be set in the device configuration for each XCP device:

Alternatively you can assign for each MEASUREMENT in the A2L a fixed or variable DAQ event channelfile. This should be considered during its creation but can also been adjusted afterwards. When you open the A2L file in the ASAP2 Studio, you can adjust the DAQ event in the Interface_XCP section:

 
Article Options
2019-11-11
Views: 35