DebugView

Question:

How to use DebugView?

Answer:
  • In Vector Hardware Config, under Global Settings set Configuration flags to 0x621 or to the value requested by Vector support.
  • Unplug Vector hardware if it is a USB device
  • Reboot computer
  • Download and unzip DebugView:
    https://docs.microsoft.com/en-us/sysinternals/downloads/debugview
  • Start DebugView as administrator
  • In Menu Capture please activate Capture Kernel and Enable Verbose Kernel Output
  • In Menu File please activate Log To File and select an appropriate file name and location
  • Plug in Vector hardware if it is a USB device
  • Please make sure, that Vector Hardware Config is closed during log file generation
  • Execute the steps to reproduce the issue. A log file will be generated at the defined location.
  • Close DebugView after the issue was reproduced.
  • Please send the log file to Vector support. If the size (zipped) is larger than 15 MB please ask for a drop zone to upload the file.
  • In Vector Hardware Config: under Global Settings reset Configuration Flags to 0x0.
  • Reboot the computer.


Article ID: 382
Last updated: 2020-02-17
Revision: 10
Hardware -> Basics and (Un)Installation -> DebugView
https://kb.vector.com/entry/382/