VX1000 Base Modules: Standby Mode

VX1060 Base Modules labeled with ECO and all VX1132 and VX1135x Base Modules support a standby mode.

These devices can enter a power-saving state which is indicated by a red-blinking PWR LED with all other LEDs off.

For this, in VXconfig in the device Network Settings "Standby Mode" must be enabled. If so, the VX device will go into standby if there is no network connection detected on the Host Ethernet port for a period which can be configured in VXconfig (the default setting is 20 s).

Here, you can also set the time the VX waits before it goes into standby mode.



Article ID: 751
Last updated: 2019-08-09
Revision: 9
Hardware -> VX Hardware Family -> VX1000 Base Modules: Standby Mode
https://kb.vector.com/entry/751/